Skip to content

Report Section 3: Discussion of Recommendations

Research workbench, not a finished commentary page.

This page is generated from processed source text and candidate catalogs. It exists to help researchers decide what to verify, promote, and deeply decode next.

FieldValue
SourceInvestigation of Some Trouble in the Generating System of the Commonwealth Edison Co.
Year1919
Section IDcommonwealth-edison-generating-system-trouble-section-02-discussion-of-recommendations
LocationPDF pages 12-16, lines 721-1138
Statuspdf-text-extracted-candidate
Word Count1622
Equation Candidates In Section0
Figure Candidates In Section0
Quote Candidates In Section3
Discussion of Recommendations While recommendations 1) to 3) should greatly reduce the frequency of troubles or keep them out of the generating system by isolating or localizing them by the feeder reactors, it obviously is not possible to absolutely guard against the occasional troubles in the generating sys- tem, such as short circuits. But as soon as the trouble is cleared as by the opening of the circuit breakers, in a second or a few seconds, the system should immediately return to normal, and to begin to pick up again the load which the short circuit dropped. The most serious feature of the troubles of September 18th, May 19th, and October 22nd, in my opinion, was that with the clearing of the short circuit, the sys- [[END_PDF_PAGE:12]] [[PDF_PAGE:13]] Report of Charles P. Steinmetz tern did
Discussion of Recommendations While recommendations 1) to 3) should greatly reduce the frequency of troubles or keep them out of the generating system by isolating or localizing them by the feeder reactors, it obviously is not possible to absolutely guard against the occasional troubles in the generating sys- tem, such as short circuits. But as soon as the trouble is cleare ...
... rt circuit at the busbars dropping out the synchronous machines in the substations while full steam supply is still on, the synchronizing power coming over the power limiting reactor is insufficient to hold the station in step, and the station breaks synchronism and speeds up. Whether synchronous operation is preserved or synchronism broken, depends on the relative speed, with which the synchronous machines in the substations drop out, the turbine governors shut off steam and the alternators speed up. The synchronous machines in the substations, carrying load ...
... tz ample synchronizing power, at full voltage, to keep the station section in synchronism with the rest of the system, even at no load but full steam supply, so that it could break out of synchronism only if the short circuit lasts sufficiently long to demagnetize the alternator fields and thereby drop the voltage. Therefore it is recommended to tie all the stations by power limiting reactors into ring connection. If a short circuit occurs at or near the busbars of a station section, it necessarily drops the busbar voltage to zero. It takes, however, a number ...
... urs at or near the busbars of a station section, it necessarily drops the busbar voltage to zero. It takes, however, a number of seconds for the short circuit current to demagnetize the alternator fields, and if therefore the short circuit is opened quickly, the alternator field magnetism is still there, at least partly, and the station voltage thus comes back instantly, at least partly. If then the station section has sufficient synchronizing power against the adjacent section, it is probable that it would remain in synchronism, no further trouble would occur, a ...
Concept CandidateHits In SectionStatus
Synchronism19pdf-text-extracted-candidate
Short circuit8pdf-text-extracted-candidate
Synchronizing power7pdf-text-extracted-candidate
Synchronous machines5pdf-text-extracted-candidate
Power limiting reactor4pdf-text-extracted-candidate
Circuit breaker2pdf-text-extracted-candidate
Term CandidateHits In SectionStatus
synchronizing power7pdf-text-extracted-candidate
power limiting reactor4pdf-text-extracted-candidate
Candidate IDOCR / PDF-Text CandidateSource Location
No chapter-local candidates yet--
Candidate IDOCR / PDF-Text CandidateSource Location
No chapter-local candidates yet--
Candidate IDCandidate PassageSource Location
commonwealth-edison-generating-system-trouble-quote-out-of-synchronism-voltage-collapselines 756-771
commonwealth-edison-generating-system-trouble-quote-limit-local-power-concentrationlines 772-786
commonwealth-edison-generating-system-trouble-quote-synchronizing-power-voltage-squarelines 855-861
  • Radiation / light: Compare the chapter’s radiation vocabulary with modern electromagnetic radiation, spectral frequency, wavelength, absorption, and illumination engineering.
  • Ether references: Verify exact wording before drawing conclusions. Ether language must be separated from later interpretive systems.
  • Field language: Read for whether field language is mechanical, geometrical, causal, descriptive, or simply a convenient engineering model.
  • Magnetism: Track flux, reluctance, permeability, magnetizing force, and loss language against modern magnetic-circuit terminology.
  • Transients / damping: Separate the temporary term from the final steady-state term and compare with differential-equation response language.
  • Radiation / light: Radiation and wave language can invite ether-field comparison, but source wording, modern radiation theory, and speculative synthesis must stay separated.
  • Ether references: If Steinmetz mentions ether, quote only the verified source words first; any broader ether-field synthesis belongs in a labeled interpretive layer.
  • Field language: Field-pressure or field-gradient interpretations can be explored here only after the explicit source passage and modern engineering translation are kept distinct.
  • Magnetism: Centrifugal/divergent magnetic-field readings are interpretive overlays, not automatic historical claims.
  • Transients / damping: Transient collapse, impulse, and surge behavior can be compared with alternative field language, but only as a clearly marked reading.
  1. Open the full source text and the scan or raw PDF.
  2. Verify the chapter boundary and surrounding context.
  3. Promote exact quotations only after checking the source image.
  4. Move mathematical candidates into canonical equation pages only after formula typography is corrected.
  5. Move diagram candidates into the diagram archive only after image extraction, crop verification, and manifest creation.
  6. Keep Steinmetz wording, modern translation, and ether-field interpretation in separate labeled layers.