Skip to content

Chapter 6: Oscillating Currents,

Research workbench, not a finished commentary page.

This page is generated from processed source text and candidate catalogs. It exists to help researchers decide what to verify, promote, and deeply decode next.

FieldValue
SourceTheory and Calculation of Transient Electric Phenomena and Oscillations
Year1909
Section IDtheory-calculation-transient-electric-phenomena-oscillations-chapter-28
Locationlines 5312-6797
Statuscandidate
Word Count4627
Equation Candidates In Section0
Figure Candidates In Section0
Quote Candidates In Section0
CHAPTER VI. OSCILLATING CURRENTS, 44. The charge and discharge of a condenser through an inductive circuit produces periodic currents of a frequency depending upon the circuit constants. The range of frequencies which can be produced by electro- dynamic machinery is rather limited: synchronous machines or ordinary alternators can give economically and in units of larger size frequencies from 10 to 125 cycles. Frequencies below 10 cycles are available by commutating machines with low frequency excitation. Above 125 cycles the difficulties rapidly increase, due to the great number of poles, high periph- eral speed, high power required for field excitation, poor regu- lation due to the massing of the conductors, which is required because of the small pitch per pole of the machine, etc., so that 1000 cycles probably is the limit of generation of constant
CHAPTER VI. OSCILLATING CURRENTS, 44. The charge and discharge of a condenser through an inductive circuit produces periodic currents of a frequency depending upon the circuit constants. The range of frequencies which can be produced by electro- dynamic machinery is rather limited: synchronous machines or ordinary alternators can give economically a ...
CHAPTER VI. OSCILLATING CURRENTS, 44. The charge and discharge of a condenser through an inductive circuit produces periodic currents of a frequency depending upon the circuit constants. The range of frequencies which can be produced by electro- dynamic machinery is rather limited: synchronous machines or ordinary alternators can give economically and in units of larger size frequencies from 10 to 125 cycles. Frequenci ...
... cy available by electrodynamic generation. It becomes of importance, therefore, to investigate whether by the use of the condenser discharge the range of frequencies can be extended. Since the oscillating current approaches the effect of an alternating current only if the damping is small, that is, the resistance low, the condenser discharge can be used as high frequency generator only by making the circuit of as low resist- ance as possible. 67 68 TRANSIENT PHENOMENA This, however, means limited power. When generating oscillat- ing currents b ...
... he power factor is cos 00 = 0.05. 72 . TRANSIENT PHENOMENA Since the energy stored in the capacity is WQ = ^ joules, the critical resistance is hence, r. - „ 0 7 = 0.025, *'4 and the decrement of the oscillation is A = 0.92, that is, the decay of the wave is very slow at no load. Assuming, however, as load an external effective resistance equal to three times the internal resistance, that is, an elec- trical efficiency of 75 per cent, gives the total resistance as r + r' = 0.2 x\ hence, and the decrement is A = 0.73; ...
Concept CandidateHits In SectionStatus
Frequency42seeded
Light4seeded
Ultra-violet radiation3seeded
Radiation2seeded
Wave length2seeded
Ether1seeded
Term CandidateHits In SectionStatus
wave length2seeded
ether1seeded
ultra-red1seeded
Candidate IDOCR / PDF-Text CandidateSource Location
No chapter-local candidates yet--
Candidate IDOCR / PDF-Text CandidateSource Location
No chapter-local candidates yet--
Candidate IDCandidate PassageSource Location
No chapter-local candidates yet--
  • Dielectricity / capacity: Check whether the passage treats capacity, condensers, displacement, or dielectric stress as field storage rather than only circuit algebra.
  • Radiation / light: Compare the chapter’s radiation vocabulary with modern electromagnetic radiation, spectral frequency, wavelength, absorption, and illumination engineering.
  • Transients / damping: Separate the temporary term from the final steady-state term and compare with differential-equation response language.
  • Waves / transmission lines: Map Steinmetz’s wave and line language onto modern distributed constants, propagation velocity, standing waves, and reflections.
  • Impedance / reactance: Translate historical opposition terms into modern impedance, admittance, conductance, susceptance, and complex-plane notation.
  • Dielectricity / capacity: A Wheeler-style reading may emphasize dielectric compression, field stress, and stored potential, but this page treats that as interpretation unless Steinmetz explicitly says it.
  • Radiation / light: Radiation and wave language can invite ether-field comparison, but source wording, modern radiation theory, and speculative synthesis must stay separated.
  • Transients / damping: Transient collapse, impulse, and surge behavior can be compared with alternative field language, but only as a clearly marked reading.
  • Waves / transmission lines: Standing/traveling wave passages may support richer field interpretations; the page keeps those readings separate from verified Steinmetz wording.
  1. Open the full source text and the scan or raw PDF.
  2. Verify the chapter boundary and surrounding context.
  3. Promote exact quotations only after checking the source image.
  4. Move mathematical candidates into canonical equation pages only after formula typography is corrected.
  5. Move diagram candidates into the diagram archive only after image extraction, crop verification, and manifest creation.
  6. Keep Steinmetz wording, modern translation, and ether-field interpretation in separate labeled layers.